6/20/2023 0 Comments Ford 2007 e150 ecu diagnostic![]() Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Enter Security Access on the PATS control function module. Cycle key to OFF and then RUN.Ģ keys required. Enter “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Retrieve DTCs from applicable PATS control function (PATS/ICM/VIC/HEC/SCIL).ġ key required. PCM disabled the vehicle because of a PATS concern. Key program failure (defective key or transceiver).Ĭommunications issue, SCP (J1850), between PCM and PATS control (PATS/ICM/ VIC/HEC/SCIL).Ĭommunications issue, CAN (J2284), between PCM and PATS control (ICM). PCM ID does not match between the PCM and PATS control (PATS/ICM/VIC/HEC/SCIL). Non-Volatile Memory (NVM) configuration failure - No PCM ID stored in PATS. Partial detection of encoded ignition key. Unprogrammed encoded ignition key detected (leave ignition on for 20 seconds before trying a programmed key, in Anti-Scan Mode). Replace transceiver.ĮCU is defective (EEPROM in PCM is not working - replace PCM). Less than 2 (or 3 if equipped w/Valet key) keys programmed to the system.
0 Comments
Leave a Reply. |